Flanged directly to the pump, the supports of our iSPi series protect the shafts of pumps and motors from high radial loads. They can also be used as support for chin belts. The housings of these supports are made of cast alluminium alloy, the shafts are machined from special steel. They are available for pumps of the following groups: 1 - 2 - ZF Bosh - 3 - 3,5. The connection is realized via spilined halfcoupling according to DIN 5482. At 1.500 rev/min support life is 3.500 hours.
Lubrification: use grease type UNI 51502-MPF-1K-20.
Flanges of the series iFFSi allow the fixing on the oiltank of inlet and outlet tubes and the maintenance or simply the check of the semi-immersed filters into the oiltank..
Mobile filtration units GF20 and GF40 are self container portable units, designed to enable hydraulic fluids to be filtered in many installations or applications.
They can be used for filling or emptying systems or as an offline filtering system. Units are equipped with Spin-on filters; a complete range of replacement canisters is available to allow almost all levels of cleanliness to be achieved. Filtration degrees from 250 µm to 3 µm are available.
Made of die-cast aluminium. Supplied complete of CCP**, cover in steel plate, GSP** gasket in iguarnitali.
Nominal capacity of 3 and 6 dm3, corresponds to 3/4 of total capacity.
LV series visual level gauges permit direct verification of the fluid level contained into the tank.
Distance iDi stated in the enclosed table, indicates the distance of the fixing holes whose diameter is iMi.
The design allows for an error of up to 4 mm, on the fixing hole centres during assembly; a new nylon black cover coating entirely the level gauge.
These level gauges can be used with mineral oils, and various fluids.
With the exception of model LV1 these gauges are also available with a thermometer.
Gauge isolators are needed to prevent that damaging pressure peak could reach the gauge. When reading the pressure value is not required, they connect the gauge to tank.
Gauge isolators type HB can be supplied to be operated by push button or rotary knob.
Oil fillers with air breather caps serve two purposes which are important on hydraulic installations:
They permit easy oil filling of the installation and they avoid the introduction of large dirty particles or objects into the tank.
They filter and clean the exchange of air between tank and outside ambiance when there are flow variations.
Copyright © 2009 HydraTek Inc. All Rights Reserved.
телефон/факс:: +7(35159) 7-93-93
тел.: +7(35159) 7-90-08
Юридический и фактический адрес: 456020, Челябинская область, г. Сим, ул. Кирова, д. 10. ООО "ГидраТек".